Waterway Executive Pump Faceplate with 2-1/2" Suction Inlet
- Waterway part #3 on diagram
- Made in the USA by Waterway Plastics
- Actual measurement of the intake is approximately 3-5/8" across the outside of the threads. Always measure your existing faceplate as the same part number can also be found on a 2" faceplate.
- Faceplate does not include drain plugs, barb fittings, or o-rings.
- Drain plugs with o-rings are sold separately if required.
- Some pumps may have a small hose instead of one of the drain plugs which would require an additional barb fitting
- NOTE: Waterway changed the design of this faceplate in late 2017. The part number remains the same however the new design requires TWO large o-rings instead of the old design which only used one. The faceplate o-rings are not included, part # 805-0261 is sold separately and this faceplate requires a total of TWO.